4g61t.org

I found them on Rockauto, but they were 78 bucks each...

_________________
~Jared, owner and operator of The Black Widow
10.24 @ 142.86, 1.58 60'
http://www.JayRacing.com

_________________
~Jared, owner and operator of The Black Widow
10.24 @ 142.86, 1.58 60'
http://www.JayRacing.com

Why did u post a pic of the fronts? Did you get your rear hubs re-drilled?

_________________
87 Starion, PROJECT. With the CATAPLT COLT engine, Thanks Craig, (GSX)
92 Eclipse GSX (Dead)
89 Colt GT (AWD Swap) H1C
88 Cummins Suburban
69 Cutlass convertible
78 Arrow G54B Swap, Celeste makeover. (MOD 2016 Veteran)

..........because that is the beginning point of this thread. 5 lug swap, front and rear. I have yet to get the rear hubs.... still looking.

_________________
~Jared, owner and operator of The Black Widow
10.24 @ 142.86, 1.58 60'
http://www.JayRacing.com

So I finally got around to ordering the rear hubs! I was measuring them and just wanted a second opinion on them being the correct ones. See pic

_________________
~Jared, owner and operator of The Black Widow
10.24 @ 142.86, 1.58 60'
http://www.JayRacing.com

Nope, those are clearly not 114.3mm. Obviously too big. Send them back. LOL They look good man.

!!!!!!!!!!!!!!!!!!!! You scared me... I mated them to my dsm rotors so they should work!

_________________
~Jared, owner and operator of The Black Widow
10.24 @ 142.86, 1.58 60'
http://www.JayRacing.com

Where did you get these? I know Rockauto had them on clearance for $50 each a while back. Either way, they are the right ones. Knock 3 of the studs out. screw the dsm rotor down with one lug nut and drill away.

_________________
93 Mitsubishi Expo LRV 1.8/manual
95 Eagle Summit DL Coupe 1.5/manual
01 Mitsubishi Mirage ES Sedan 1.8/manual

Also just to be safe, you may want to try them on your car or at least measure the inside of the bearing. Just to make sure they aren't expo hubs.

_________________
93 Mitsubishi Expo LRV 1.8/manual
95 Eagle Summit DL Coupe 1.5/manual
01 Mitsubishi Mirage ES Sedan 1.8/manual

OK will do.

I forgot to ask, where can I get some brake pads for the rear calipers?

_________________
~Jared, owner and operator of The Black Widow
10.24 @ 142.86, 1.58 60'
http://www.JayRacing.com

Pretty much anywhere, they are the same as 1g dsm rear pads.

_________________
93 Mitsubishi Expo LRV 1.8/manual
95 Eagle Summit DL Coupe 1.5/manual
01 Mitsubishi Mirage ES Sedan 1.8/manual

Wish I would have known some of this stuff before I did my swap. I'm actually running dsm knuckles and hubs on the front of the car right now. I am using the Yoshifab camber plates, which are pushed all the way in. I want to lower the car about another few inches so I think I will be able to push them back out when I get new suspension. As for the tie rods, all I did was flip them. The tie rods themselves look fine to me, no crazy angles at all and the car seems to have no bump steer.

_________________
92 Colt GL 4g63t + AWD swap
00 Mirage LS

Sorry I'm late...

http://www.youtube.com/watch?v=jUBIAIDu9-I

http://www.youtube.com/watch?v=OiCTYJiem0U

http://www.youtube.com/watch?v=m6mRJ9ZImcY

I wish I could offer more for the FWD rear 5-lug stuff, but I AWDed it so I'm no help. I found this thread thanks to a subscriber question. This should clear up the process on the fronts pretty well for any newcomers.

@aaronsbig16g There's some good info about ride height for the fronts in the last video. It includes all the parts and part numbers I used for the front end. The Megan Racing DSM springs were $129 new but I really didn't need the rear ones at all (if you go through my AWD rear swap videos, you'll see why).

Edit: I also credited 89MirageMan and ColtsFan in the info section because really they're the ones that did all the heavy work many years ago.

_________________
Jafro
95 GSX
91 Banana Yellow Colt

Very nice work once again . This should clear up a lot for others out there wanting to do this swap.

_________________
93 Mitsubishi Expo LRV 1.8/manual
95 Eagle Summit DL Coupe 1.5/manual
01 Mitsubishi Mirage ES Sedan 1.8/manual

Great video's! Very informative and entertaining.

And thanks for the tips! I think I'm running dsm shocks right now but this winter I'm going to upgrade to a koni/ground control combo, for sure going to try to get my hands on a set of mirage fronts.

_________________
92 Colt GL 4g63t + AWD swap
00 Mirage LS