I decided to partout my entire collection of parts I had sitting for my 29k mile gsx and just make the car stock.
Built longBlock:
-6- bolt
-Bored .20 over
-Ross Racing Pistons (8:3 to 1)
-Manley H-Beam Rods
-Acl main and rod bearings
-Balance shaft eliminator kit
-New oem oil pump
-New alternator
-New front and rear main seals
-New oem crank pulley
-New oem tensioner
-Greddy kevlar racing timing belt
-ARP Mains
-OEM Mitsubishi oil filters with Mobil 1 oil
-Full port job done by Norpa machine in Woodbridge, Va
-Complete valve job
-Manley 1mm oversized valves with valve springs and retainers
-New valve stem seals
-Cometic head gasket
-ARP headstuds
-Receipts for motor internals. I drove this setup for 5 hours straight back from VA where I bought the car and it drove perfect. Compression is perfect as well. This entire setup has slightly more than 1k miles on it.
--I will sit on this for months if I get lowball offers unless I need space or something--
-2000
-HKS Drager catback exhaust (500 miles)- 325
-Victory Performance FMIC kit w/ greddy type r bov(over 1200 new retail--big boy IC setup!!!)- 500 for kit minus bov or 600 for kit w/ bov

-Fuel Injector Clinic 850 cc Fuel Injectors- 140
Greddy Electronic 60mm boost gauge-100

Greddy electronic 60mm EGT gauge w/ probe- 175

-Eprom ECU with Version 1 DSMLink- 390

-Barely used Sparco Milano black/ grey seats w/ sliders (over 2000 new)-800
-BAER Pro Big Brake Kit – 4 piston calipers with 13.5†rotors (cross drilled)- 700

-Rays Engineering Gram Lights 57c rims painted black w/ dunlop tires- 800
-Blitz SBC-ID boost controller- 200
-Blitz Power Meter ID- 100

-Front ebay and rear RRE strut tower bars- 75
-autometer a/f ultralite gauge- 15
-Full Infiniti Kappa Perfect Component System Infiniti Kappa Perfect 6x9 3-way speakers- 125
_____________________________________________________________________________________
I am parting a 97 GST. All larger items are picked up in 17754, or I can deliver them up to a certain distance for a fee.
Rolling shell w/ 100k miles on it. The car has an authentic Rudora bodykit and is painted Lexus 2004 Lexus "Crystal White". The kit and paint cost more than 3k alone. There is absolutely no rust on the shell and was never in an accident. The rolling shell will not come with motor/ trans. It will include:
18" ADR Kasai's in Black (two have curb rash and some paint fade) w/ Practically new tires- 300
Thermal 3" exhaust catback 375
Apexi GT-Spec Stainless Steel 3†downpipe-100
VERY sought after black interior minus the seats best offer
ACT 2600lb clutch w/ streetdisk 5k miles- 190
ACT2600 w/ 6 puck only 1k miles on setup- 200
7 bolt fwd Fidanza lightened flywheel- 110
18's w/ practically new sumimoto tires- 500

Buscher 20G Turbo (ported and clipped) w/ feed and drain lines/ coolant lines, 2.5" o2 housing w/ 5k miles-650

magnecore plug wires- 30

denso 660cc injectors-125

3" Intake pipe w/ GM MAF and MAFT- 175

2g gauge cluster w/ 89k miles--has 10k rpm limit and 200mph limit white overlays (clear cover comes with it--just not pictured)- 65

dual gauge pod w/ autometer a/f - 25

stock infinty cd player full din- 25

brand new car alarm system in box- 50
2g mas- 25
2g coil pack- 25
misc sensors
stock clutch w/ 29k miles- 30

2g awd 2 piston brakes- 40 /pair

2g talon tails- 25
1g head w/ cams- 100

1g head ported slightly and supposedly recently rebuilt (snapped timing belt--bent valves)- 50

2g rad (has a cracked off piece around the top fill tube, but still is good to use) -20
doors with glass and power locks and windows--driver side has broken handle- 40 each or 65 for pair
2gb talon rear bumper- 30
2gb talon wing- 40

2gb black housing headlights in good condition- 50
non-eprom 2g turbo ecus- 40

hatch with glass- 45
6 bolt awd flywheel

airbags- 35
motor mounts- make offer
black 2g hood with some dings-30
rear calipers- 35

Alpine CDA-9884 CD & MP3 Receivers-75

Clarion cd deck- 75
engine harness wired for 6 bolt swap- 80

engine harness from 97- 80
2g awd rotors in good shape- 25
Pics of anything upon request. Prices do NOT include shipping.