4g61t.org

As some may know, Two weeks ago i drove 4 hours to northern Ohio to pick up this beauty for my girlfriend. Its a 91 Dodge colt, 2.0 turbo swapped. had a few mods.

Abortion chicken scratch BOBO POS everyone learned to weld on Manifold (modded pace setter that used to be on pttcolt's car)
china bay 50trim
550's and a walbro
Clutch Tech 6 puck with 2100 PP
Coil over sleeves
rear AGX's
new DR's
Acura wheels
Big front brake mod(drilled and slotted elantra rotors, 1G calipers)
FMIC
38mm waste gate
modded for direct plug and play wiring harness(factory tach doesnt work though?? think it might be since the car harness is pre91 and engine harness is a 91)
2g Maf
Car has a GT clutster init


Here what it looked like when i picked it up.






Since then, We've pulled the engine, and completely stripped the engine bay. there are a few small rust issues as you can see. But we spend almost 2 hours Scrubbing and cleaning the engine bay. And it was alll for a good reason, My buddy Dale, T2fastalon is painting it tomorrow, It'll be Pearl white. heres some pics of the cleaner engine bay




I think it looks a little better for now. after tomorrow it should look VERY nice!!!

I also tore the seats out, and cleaned up the carpet a bit.




So since we've had the car for a week, we've done alot.. we've also gotten a few new things

New boost guage
New oil temp. guage.
3 3'' Ubends for exhaust. -
FMIC kit
Junk yard short block with
SSAC manifold -




let me know what you guys think



Also, a HUGE thanks goes out to my buddy Brent for letting me use his garage!!

Lookin' good man. That engine bay is looking real clean. I can't wait to see the finished product.

_________________
91 GSX - 511fwhp and 352 lb/ft 25psi 110 octane, 7.68 @ 95.9mph 1/8th 21psi 91 octane, 11.93 @ 112.9mph, 117.7mph best trap speed, 20psi 91 octane
98 Volvo S70 T5 - DD

http://www.facebook.com/captaintonus

Looking foward to the after fresh paint pics.

_________________
John
89 Colt GT(2)
88 d50 4g63t, crower 272's, dsmlink

Two csm's, it's official. You're Hooked ! Looking good so far man. Always liked white on the hatches for some reason.

_________________
93 Mitsubishi Expo LRV 1.8/manual
95 Eagle Summit DL Coupe 1.5/manual
01 Mitsubishi Mirage ES Sedan 1.8/manual

This one isnt mine. Its my GF's. But this is the 4th white hatch i've had.

_________________
91 colt beater..

Here are some pictures of the engine bay after paint. A huge thanks goes out to T2fastalon


I didnt get a change to fix that rust on the pass or drivers side, So here is the pass side. I just cut it out for the Intake pipe, Maybe even the IC pipes.




And here are some of the finished product. Ill get some tomorrow in the sun light, and get the pearl shining.






Let me know what you think.

_________________
91 colt beater..

Nice!
You want to de-rust and repaint mine next?

VERY NICE... YA, THATS RIGHT MY UNFINISHED SEX!!!!

where the hell is the clutch cyclinder?

_________________
my three diamonds beats your 5 LITERS

95 tsi awd- 13.78
91 summit- A.K.A the blue bastard- swapin that beeeotch as we speak

looks to b cable clutch. thing is looking good man.. im liking this project.
keep it up.

you are correct.. It is still a cable clutch car. Its also still a 4speed. HAHA. This is a budget build, so it'll work untill it blows.

_________________
91 colt beater..

Oh yes, that 4spd tranny is probably AWESOME with the 4G63 swap.

_________________
91 GSX - 511fwhp and 352 lb/ft 25psi 110 octane, 7.68 @ 95.9mph 1/8th 21psi 91 octane, 11.93 @ 112.9mph, 117.7mph best trap speed, 20psi 91 octane
98 Volvo S70 T5 - DD

http://www.facebook.com/captaintonus

i got inspired from this.. for the talon

http://img.photobucket.com/albums/v467/ ... C05487.jpg
http://img.photobucket.com/albums/v467/ ... C05488.jpg
http://img.photobucket.com/albums/v467/ ... C05489.jpg

just got finished an hour ago.

took about 2 1/2 hours with a friend.

w00t

did you just rattle can it? You shoul dhave tapped things off a bit better. Spray paint in an engine bay is almsot useless. I did it a few times. and it just flakes off

_________________
91 colt beater..

yeah i rattle canned

i used primer spray first
then the white paint can
then a clear coat can.

all of this was done after a clean up with a engine bay cleaner.