well...ok, so i buy the wrong mounts and i find this out AFTER i put the motor in the bay and its resting on the cross member. Fine, i get the right rear mount and put it on and the mount is on the wrong side of the rubbber mount. So i start pondering, realizing i let a friend borrow the hoist all i had was me, 2 jackstands and a jack. pondering some more and then it sorta clicked...raise the engine on the flywheel side and pull it off the jacks so it sets into the rubber mount. What do you know? it works it took me 2 hours to get it into position so i can pull it, but i was successful.
Finally my girlfriend came and she helped me align the bolt holes and she put them bolts through. Thank god she came!
so now...its mounted
today comes tranny and vac lines and thursday come exhaust and then PSSSSSSSSSSSSSSSSSSSSSST
Dominik 1, 4g63t 0
not a bad kill eh?
-Dom