4g61t.org

Specializing in the 3g CSM
It is currently Thu Mar 28, 2024 5:42 pm

All times are UTC-05:00




Post new topic  Reply to topic  [ 8 posts ] 
Author Message
PostPosted: Thu Sep 15, 2016 1:53 pm 
Offline
Some call me a god

Joined: Tue Nov 12, 2002 1:08 am
Posts: 1477
Location: Cleveland
Crazy, but I have tuned more DSMs this year than any other year since 2005.


Quick street tuned a Galant Vr4 yesterday, and after diagnosing a bad COP, had it at 40psi and rippin' in just a few pulls.

Just wanted to post that I was quite surprised at the spool for a 70+ lbs/min turbo. We saw 30psi @ 4200 in 3RD gear!!! No room for 4th gear pulls, but it can be assumed it would be a bit faster in 4th. Sucker held 40psi to redline too. 8.5 to 1, 2.0, E85. Factory Holset turbine, full divided set up. Real Crower 272s, 16cm divided Holset turbine No fancy tricks.

This was a "3 pull" tune just to get the car driving well enough for him to put some miles on it-far from done. May be on the dyno with it in a month if time permits.

That is all. Keep boostin' :cool:

_________________
Current
95 Mirage AWD - "HoboEvo" 1008 awhp 9.5@165
08 535ix 420awhp
06 C6 Z06- 600whp NA


Top
   
PostPosted: Thu Sep 15, 2016 2:28 pm 
Offline
Spends Too Much Time Under The Hood
User avatar

Joined: Sun Jun 03, 2007 5:44 pm
Posts: 306
Location: Cleveland / D.C.
That thing spools a ton better than the Bolt-on Bullseye .55 housing hx40 I had on my car. What kinda airflow number were you seeing? Stock intake manifold, intercooler piping size??? My t3 cast wheel 3582r isn't seeing full boost until like 6k and trying to figure out what's causing it whether it's the old Forrester intake manifold, the old turbo or what? I've got this 6466 sitting here staring at me and I've kinda been itching to throw it on and see what changes. It should pretty much be a direct swap after plugging some coolant lines.

_________________
'89 Summit Sedan AWD - 9.1 at 157
'92 Evo 1
'10 CTS-V


Top
   
PostPosted: Thu Sep 15, 2016 11:01 pm 
Offline
Some call me a god

Joined: Tue Nov 12, 2002 1:08 am
Posts: 1477
Location: Cleveland
Quote:
That thing spools a ton better than the Bolt-on Bullseye .55 housing hx40 I had on my car. What kinda airflow number were you seeing? Stock intake manifold, intercooler piping size??? My t3 cast wheel 3582r isn't seeing full boost until like 6k and trying to figure out what's causing it whether it's the old Forrester intake manifold, the old turbo or what? I've got this 6466 sitting here staring at me and I've kinda been itching to throw it on and see what changes. It should pretty much be a direct swap after plugging some coolant lines.
I can have the guy email me the log. I mean hell I set up the base tune right? :)

Its a Magnus IM, old scool. 2.5 pipes. Do you have an .82 turbine? Still pretty slow. If you have link cotroling boost try to mad the duty cycle to the top port and pull a little timing out of iton spool up. I can take a peek at it next time your in town if you like- but looking at your vids I'd say she's rockin!

_________________
Current
95 Mirage AWD - "HoboEvo" 1008 awhp 9.5@165
08 535ix 420awhp
06 C6 Z06- 600whp NA


Top
   
PostPosted: Fri Sep 16, 2016 8:12 am 
Offline
Some call me a god
User avatar

Joined: Mon May 18, 2009 8:53 pm
Posts: 1494
Location: Seattle, WA
That's crazy compared to my 16g 4g61t Colt, full boost in 3rd 15psi @ 5k RPM lol. but it is on stock exhaust.

_________________
89 Mirage Billet 20g 63t 12.4@120 417whp 400wtq @ English Racing.
89 Colt GT E316g
06 Silverado SS
07 ZX6R


Top
   
PostPosted: Fri Sep 16, 2016 2:57 pm 
Offline
Spends Too Much Time Under The Hood
User avatar

Joined: Sun Jun 03, 2007 5:44 pm
Posts: 306
Location: Cleveland / D.C.
Quote:
I can have the guy email me the log. I mean hell I set up the base tune right? :)

Its a Magnus IM, old scool. 2.5 pipes. Do you have an .82 turbine? Still pretty slow. If you have link cotroling boost try to mad the duty cycle to the top port and pull a little timing out of iton spool up. I can take a peek at it next time your in town if you like- but looking at your vids I'd say she's rockin!
Pretty damn impressive for that setup. And yea I'm still on the .82 with Link controlling boost from both top and bottom port off the solenoid. My issue is in between shifts (8500) I'm going down to as little as 7psi while it ramps back up. Might be keeping the trans alive but definitely not helping me. Like you said though, it's running decent and planning to switch the setup a bit over winter anyway so might as well leave it for now and not mess with it too much.

_________________
'89 Summit Sedan AWD - 9.1 at 157
'92 Evo 1
'10 CTS-V


Top
   
PostPosted: Fri Sep 16, 2016 4:42 pm 
Offline
Some call me a god

Joined: Tue Nov 12, 2002 1:08 am
Posts: 1477
Location: Cleveland
Quote:
Quote:
I can have the guy email me the log. I mean hell I set up the base tune right? :)

Its a Magnus IM, old scool. 2.5 pipes. Do you have an .82 turbine? Still pretty slow. If you have link cotroling boost try to mad the duty cycle to the top port and pull a little timing out of iton spool up. I can take a peek at it next time your in town if you like- but looking at your vids I'd say she's rockin!
Pretty damn impressive for that setup. And yea I'm still on the .82 with Link controlling boost from both top and bottom port off the solenoid. My issue is in between shifts (8500) I'm going down to as little as 7psi while it ramps back up. Might be keeping the trans alive but definitely not helping me. Like you said though, it's running decent and planning to switch the setup a bit over winter anyway so might as well leave it for now and not mess with it too much.

I have seen gates hang open. Its worth checking if you have an issue. Take it off-it it with air, see if it shuts quickly on its own. Make sure your bottom port is on a INTAKE MANIFOLD souce, and the top port is SEEING BOOST when you are in ramp up.

_________________
Current
95 Mirage AWD - "HoboEvo" 1008 awhp 9.5@165
08 535ix 420awhp
06 C6 Z06- 600whp NA


Top
   
PostPosted: Fri Sep 16, 2016 9:36 pm 
Offline
Some call me a god

Joined: Tue Nov 12, 2002 1:08 am
Posts: 1477
Location: Cleveland
Here is a shot fo the Log from 3rd gear. Little faster spool in 4th

http://i1003.photobucket.com/albums/af1 ... si4400.jpg

_________________
Current
95 Mirage AWD - "HoboEvo" 1008 awhp 9.5@165
08 535ix 420awhp
06 C6 Z06- 600whp NA


Top
   
PostPosted: Sun Sep 18, 2016 9:23 am 
Offline
CSM Junkie

Joined: Sat Dec 20, 2008 7:45 am
Posts: 505
Location: tampa
very nice. proper twin scroll effort can be very rewarding


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 8 posts ] 

All times are UTC-05:00


Who is online

Users browsing this forum: No registered users and 23 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Limited