4g61t.org

I went down to the local speed shop the other night to watch my friend's 350z getting tuned. I started chatting with one of the guys working there that i never met before. He told me he was from Australia and that he comes here a few times a year to work at this shop and race. To make a long story short, i asked him if he could possibly bring me some "parts" back from Australia the next time he goes home. He said to get him a couple of pics of what i might want and he'd see what he could do. Can you imagine the possibilties this may open up? 1st US Cyborg? I'd like to see if he could get me a bumper and Cyborg crossmember first. If it works out well, i'll start taking suggestions on what else to import. Let's hope for the best guys!

_________________
go fast- break stuff- repair- repeat

Sounds promising.

_________________
Had a:
1991 Eagle Summit ES Hatchback - 4g15 12v 5spd
1991 Dodge Colt -4g15 12v 4spd
Have a:
1978 Oldsmobile Cutlass - 468BBO TH350
Round 3:
1990 Dodge Colt-4G63T 5spd

definately.. i'd be game for a borg bumper and crossmember

+1

_________________
John
89 Colt GT(2)
88 d50 4g63t, crower 272's, dsmlink

the bumper will be easy to find,

but unfortunatly there is only about 8-15 cyborgs in Australia. Most of them are in NZ.

I was going to same the same thing t04, but I couldn't put a figure on it other than to say, "not a lot delivered there, so try NZ".

If you get a bumper, make a mold, and start cranking them out!

oh yea i have been watchin the other forums looking for a bumper/ kit to import cause i want one so bad

i want a bumper.

just the borg eurathane bumper. i don't want a fiberglass replica.

_________________
If speed kills, then i shoulda been dead awhile ago. There is no such thing as "Too Much Power". There is no excuse for a lost race. Do you view the rev limiter as a fun limiter?or as a shift point? And we all know, more boost=more fun.

bumper bumper bumper front and rear!

Yeah, I would be interested in a real urathane cyborg bumper as well... please find out if he can get a few of them to you!

its not hard finding them, its the freight thats killer!

T04, can you get some prices in USD? Shipping prices too

seriously, thats all to hard hahahaha,

i just did a quick Fedex only rate check thing, and for a package that is

L=170cm, H=60cm, W=40cm with a weight of 15kg's is like 1200AUD,

oh and that was to madison, wisconsin as an example.

if any one else can get a quote from, Perth, Western Australia, Postcode 6000 and is willing to pay, i can try and find some bumpers.

they crop up every now and then, i found a rear JDM facelift for my car for $50AUD here, and i think fronts go for around $150, but it all depends on what is going around at a particular time.

dont PM me till you find freight your happy with.

i'll have to check for freight to wilmington delaware