4g61t.org

I need lots of the clips that hold the side mouldings (the bump guards) onto the doors. I need a lot of them so if there's a ton of csm's in your local yards, start yanking!

Also needed, 5 center vent sections, the vents that are right above the hvac controls in the dash. I've got a few ideas for winter projects.

_________________
Had a:
1991 Eagle Summit ES Hatchback - 4g15 12v 5spd
1991 Dodge Colt -4g15 12v 4spd
Have a:
1978 Oldsmobile Cutlass - 468BBO TH350
Round 3:
1990 Dodge Colt-4G63T 5spd

A local automotive store should have those clips really cheap and they wont be all dried up and cracking. I broke almost half of mine getting the plastic trim off and I think the replacement cost was about $10.

_________________
- Works in da bush

I've dug through the racks we've got at the stores here but haven't been able to find an exact match. Everything is too loose or the wrong height.

_________________
Had a:
1991 Eagle Summit ES Hatchback - 4g15 12v 5spd
1991 Dodge Colt -4g15 12v 4spd
Have a:
1978 Oldsmobile Cutlass - 468BBO TH350
Round 3:
1990 Dodge Colt-4G63T 5spd

www.thefastenerwarehouse.com

Not sure if this one will work but it sure looks close.
http://www.thefastenerwarehouse.com/cat ... 181277.htm

_________________
93 Mitsubishi Expo LRV 1.8/manual
95 Eagle Summit DL Coupe 1.5/manual
01 Mitsubishi Mirage ES Sedan 1.8/manual

I got the 5 central vents for you. PM me with your address.

_________________
Good stuff - trucks bring it!

i have a dodge dealership right by my house i can see if they have your clips and i can get them shipped to you if you like i can let you know a total cost just pm me if your interested

MB319754 is the part # for said clips.

The same clip also holds the lower trim portion onto the door on 1990-1991 TELs according to the parts program.