4g61t.org http://www.4g61t.org/forum/ |
|
Colt GT project from Jeff aka Duraldc http://www.4g61t.org/forum/viewtopic.php?f=64&t=38962 |
Page 2 of 2 |
Author: | Flying Eagle [ Mon Aug 17, 2015 10:20 pm ] |
Post subject: | Re: New Colt GT project gift from Jeff |
Well, that would not be the appropriate way to make power then would it! Haha. |
Author: | cheaptalon [ Wed Feb 10, 2016 11:06 pm ] |
Post subject: | Re: New Colt GT project gift from Jeff |
Did you change the brake booster too, or just the master cylinder? |
Author: | xxNocturnalxx [ Thu Feb 11, 2016 2:20 pm ] |
Post subject: | Re: New Colt GT project gift from Jeff |
Just the master as it was leaking anyway and I wanted to try it out. There is a very noticeable difference in pedal feel. It's much tighter and responsive. Going to do the same on the Mirage when I find another one. |
Author: | xxNocturnalxx [ Mon Feb 15, 2016 11:41 am ] |
Post subject: | Re: New Colt GT project gift from Jeff |
Okay, got a seat belt control unit from a local member... Pulled the car into the garage, installed the CU.. the auto belts work great yay! Now the car doesn't start I'm thinking I should of had the battery disconnected during the install and maybe I fried something? The fuel pump turns on and it seems to get fuel pressure, No CEL either, that's all I know at this point. Grrr. |
Author: | mattp_65 [ Mon Feb 15, 2016 1:25 pm ] |
Post subject: | Re: New Colt GT project gift from Jeff |
Nice I like the intake. Where did you get it Corey? Loose connection when removing the old board, by accident maybe? |
Author: | xxNocturnalxx [ Mon Feb 15, 2016 3:55 pm ] |
Post subject: | Re: New Colt GT project gift from Jeff |
The Filter? It's a K&N I got off ebay. The piping is just some universal stuff I had laying around. The new seat belt CU I never opened, it's just one plug and all that works well, the old one had been fried sense I've owned the car. EDIT: Found out the no start was a loose connector on the ECU, I must have pulled it out while tucking the carpet back in. |
Author: | xxNocturnalxx [ Fri Mar 25, 2016 11:38 am ] |
Post subject: | Re: Colt GT project from Jeff aka Duraldc |
Hood was becoming impossible to pop, solved that with some flush locks. |
Author: | Flying Eagle [ Sat Mar 26, 2016 8:08 pm ] |
Post subject: | Re: Colt GT project from Jeff aka Duraldc |
Double nice touch with the sticker and the hood catches. I hear you about the hood latch getting tight. My LF door lock inner device and my hood pull are both tight, more so in the cold. Even installed a new cable, but it isn't run up the top side of the inner firewall, like factory. No way I was taking out dashbard stuff to get into there. I thougth I received a 1G DSM cable, and only after pulling a dash did I realize where the extra cable went to. |
Author: | xxNocturnalxx [ Mon Mar 28, 2016 10:19 am ] |
Post subject: | Re: Colt GT project from Jeff aka Duraldc |
Yep and now my gas door cable seems to be getting tight too, grrr. |
Page 2 of 2 | All times are UTC-05:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |