Holy frack=nice
What psi you gonna run?
| 4g61t.org http://www.4g61t.org/forum/ |
|
| Fathouse Fabrications LILEVO turbo build http://www.4g61t.org/forum/viewtopic.php?f=64&t=36652 |
Page 1 of 1 |
| Author: | LILEVO [ Mon Jul 30, 2012 4:42 pm ] |
| Post subject: | Fathouse Fabrications LILEVO turbo build |
Spent the weekend at FatFab. Kick ass shop ran by two sushi loving lunatics. Great prices and excellent fab work in centrally located Indianapolis. They will make your dreams come true! Turbo is a PTE 6466, Fatfab manifold, custom 3" O2 housing with recirc, and a Tial MVR. Hellooo power! Pictures in process http://lilevo.com/lilevo2/6466/ Few pictures of the completed setup. http://wikked.com/lilevo/newtrubo/ |
|
| Author: | UnderPSI [ Mon Jul 30, 2012 5:33 pm ] |
| Post subject: | Re: Fathouse Fabrications LILEVO turbo build |
I love that set up. Those v bands save tons of time when you go to take things off. Lookin good. |
|
| Author: | aaronsbig16g [ Mon Jul 30, 2012 7:41 pm ] |
| Post subject: | Re: Fathouse Fabrications LILEVO turbo build |
Looks so good! Wish I could have come and hung out but I had a previous engagement. Fatfab does amazing work and are awesome guys to hangout with. I plan on getting a manifold made this winter. |
|
| Author: | Natedog [ Mon Jul 30, 2012 7:47 pm ] |
| Post subject: | Re: Fathouse Fabrications LILEVO turbo build |
Great guys! Looks great Jason! |
|
| Author: | quikgt [ Mon Jul 30, 2012 10:00 pm ] |
| Post subject: | Re: Fathouse Fabrications LILEVO turbo build |
Holy frack=nice What psi you gonna run?
|
|
| Author: | LILEVO [ Mon Jul 30, 2012 10:06 pm ] |
| Post subject: | Re: Fathouse Fabrications LILEVO turbo build |
However much the eagle/ross motor will hold. Probably 40-45psi. Keep it around 750awhp. Ran great at 38psi on the short test drive the other night. If/when these pistons/rods give out then 45-50psi on a new motor |
|
| Page 1 of 1 | All times are UTC-05:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|