4g61t.org http://www.4g61t.org/forum/ |
|
no clue what to title this one lol http://www.4g61t.org/forum/viewtopic.php?f=6&t=41011 |
Page 1 of 1 |
Author: | slowdsm [ Mon Apr 17, 2017 10:07 am ] |
Post subject: | no clue what to title this one lol |
so im building a 2.0 for my van.. getting the eagle H beam (1g) rods with the 22mm small end.. my question is do I buy 2g pistons (which I assume I do) and next is do I need to do any machine work to the rod/pistons to make them fit? i read in the past when using that combo u had to have either the piston or rod machined to clear the piston.... but that was with stock parts.. and other than the hole. thx Steve |
Author: | Keane [ Mon Apr 17, 2017 3:39 pm ] |
Post subject: | Re: no clue what to title this one lol |
I believe in the old days the 1g small end was also to fat to fit in the 2g piston but I'm sure that's addressed now that they make a 1g rod with the 2g 22mm end on it. I think the only other thing was to verify no contact on the piston oil squirters. If there is contact Either bend them or go to the evo squirters |
Author: | slowdsm [ Mon Apr 17, 2017 3:56 pm ] |
Post subject: | Re: no clue what to title this one lol |
so 2g pistons and watch for squirters . got it thx. |
Page 1 of 1 | All times are UTC-05:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |