ive been reading about upgrading the 14b to a 16g or 20g.... I have a mhi evo3 16g from back in 2003 when they first came out.. the center section has some chunks taken out of itso its no good. can I take the bigger (cold side) wheel and the bigger cold side housing and put them both onto the 14b center section? (i actually have it put together minus the locking nut) it looks like it will work.
so my next question is.. has anyone done this... are they the same except the housing and larger wheel? if it will work then I just need to find a left hand threaded nut cause the stock 14b one is right hand thread. and I lost the original 16g one
... or can I still use the 14b shaft with exhaust wheel on it. (they measure out as the same wheel on the hot side)..
Steve