If you need the equal length halfshaft assembly let me know cause i just pulled them. They look to be remanufactured too
-bit
| 4g61t.org http://www.4g61t.org/forum/ |
|
| AWD tranny + pass. side axle = No go http://www.4g61t.org/forum/viewtopic.php?f=6&t=19924 |
Page 1 of 1 |
| Author: | Phlipfreq [ Thu Jan 04, 2007 11:54 am ] |
| Post subject: | AWD tranny + pass. side axle = No go |
I'm having issues getting the passenger side axle to stay in place. Can anyone help me out? |
|
| Author: | slowdsm [ Thu Jan 04, 2007 1:31 pm ] |
| Post subject: | |
try a welder.. or give us more info on what its doing? either way works great |
|
| Author: | gsx [ Thu Jan 04, 2007 2:27 pm ] |
| Post subject: | |
I am assumimng you are trying to put a non-equal lenght half shaft into a AWD trans. I am pretty sure that the AWD side gear does not have a groove cut into it to catch the C-clip. You will need to run the two piece half shaft(equal lenght). I also got a trick from PTTcolt that to bolt the halfshaft to the back of the block without the A/C plate that goes under it. Use two 6bolt head bolt washers under each bolt (4 total). Worked great in my car for a year. |
|
| Author: | LILEVO [ Thu Jan 04, 2007 3:13 pm ] |
| Post subject: | |
It pops out of the transmission constantly? I have 1G and 2G AWD trannies in my car and never had any problems with an 89 Mirage Turbo passenger axle. I had a problem of it constantly popping out and I believe it was due to not having a 1.6L turbo axle. See my "4G63 Swap" link on my webpage, at the bottom. Shows the axle differences. What problem are you having? |
|
| Author: | BitAddict [ Thu Jan 04, 2007 9:26 pm ] |
| Post subject: | |
If you need the equal length halfshaft assembly let me know cause i just pulled them. They look to be remanufactured too -bit |
|
| Author: | Phlipfreq [ Fri Jan 05, 2007 4:09 pm ] |
| Post subject: | |
Its working now, I think hopefully it wont pop out:/ |
|
| Author: | MR HYDE [ Wed Jan 10, 2007 5:34 pm ] |
| Post subject: | |
Quote: I am assumimng you are trying to put a non-equal lenght half shaft into a AWD trans.
Equal length 1G is for the drivers side. He is referring to the passenger side and should use the 1.6T axle on that side |
|
| Author: | MR HYDE [ Wed Jan 10, 2007 5:36 pm ] |
| Post subject: | Re: AWD tranny + pass. side axle = No go |
Quote: I'm having issues getting the passenger side axle to stay in place. Can anyone help me out?
Is it a 1.6T axle? There should be no reason why the axle would pop out of the hub assembly or tranny. Is the axle popping out of its' cups?
|
|
| Author: | Phlipfreq [ Wed Jan 10, 2007 9:34 pm ] |
| Post subject: | |
I got both axles in, but theyre both 4g61t axles should I expect problems |
|
| Page 1 of 1 | All times are UTC-05:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|