4g61t.org
http://www.4g61t.org/forum/

How to lower a '94 Integra With DSM Parts for free.
http://www.4g61t.org/forum/viewtopic.php?f=42&t=31169		 Page 1 of 1
Author:  93'TSIColt [ Fri Nov 20, 2009 4:01 pm ]
Post subject:  How to lower a '94 Integra With DSM Parts for free.
Heres how you lower or SLAMMMM a integra for free


Image
Image
Image

HAHHAHA Who needs a truck??? not me! ahha

Had the block... tranny, tcase, axles, engine brackets, water pumps, 1990 oil cooler/lines, complete engine hoist and all my tools i have in the car. Thank god for fold down rear seats!

The block is a built up 6 bolt... with eagle rods and melted weisco pistons... not bad for free!

Got myself a "new to me" 6 bolt block with melted wiesco pistons and a 1990 tranny/t-case wooohoo! Im hoping the crank and the Eagle rods are still in good shape! Should need new pistons and a good hone of the cylinder walls and it should be good to go.

Heres the pics of the pistons. First pic is the worst of them..... #1 piston
Image

#2 piston
Image

What do you think?? repairable easily with new pistons and a hone?
Author:  89Mirageman [ Fri Nov 20, 2009 10:23 pm ]
Post subject:  Re: How to lower a '94 Integra With DSM Parts for free.
They look good from what I can tell but even if you have to get it bored you can't beat it for free. Integras are much bigger than they look. I remember when miragerunner came to my house and we went to the junkyard. We were able to cram a bunch of parts in his car and still got the hatch to close.
Page 1 of 1 All times are UTC-05:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/