4g61t.org
http://www.4g61t.org/forum/

Rattlesssss
http://www.4g61t.org/forum/viewtopic.php?f=28&t=5417		 Page 1 of 1
Author:  200Gt-R [ Wed Sep 24, 2003 8:06 pm ]
Post subject:  Rattlesssss
please tell me what you do with the rattle...
Author:  dsmracer [ Thu Sep 25, 2003 12:31 am ]
Post subject: 
Tighten down as much crap as you can. If that doesn't work, use some double-sided foam tape to insulate the part and keep it from rattling.
Author:  T__K__A [ Thu Sep 25, 2003 10:45 am ]
Post subject: 
I agree with that. I striped my entire interior and layed down roofing tar on the floor, doors, roof, trunk. Bass got sooo much better then I went to the local home depot and picked up 3/4" underlay (the stuff you put under carpeting so you cant hear whats going on in the basement or whats happening upstars) so I put all that down then put my interior back together tight. No more rattles, ALOT less road noise and bass perfection!! I had 2 pioneer 12's (pieces of shit) runnin on a 800 watt orion and ppl could hear me comming 2 km away! No bullsh*t. I went to fill up with gas one time and the owner came out to ask me to "please turn it down" cause apparently I was rattling stuff inside the store :twisted:

Image

Image
This one is taken from the trunk ^. I didnt take the dash off at that point
Author:  socrateez [ Thu Sep 25, 2003 7:42 pm ]
Post subject: 
I have a problem with the plast trim fasteners in the hatch area and the screws on the rear speaker mounts. About once a month i have to dig around and collect half a dozen or so and replace/tighten them. Lock-tite here i come!
Author:  Loud Brown Kicker Colt [ Wed Oct 13, 2004 3:42 am ]
Post subject: 
Urethane adhesive(windsheild glue) works wonders,and urethane foam for real problem panels(ringing Q panels). 8)
Author:  Silforty element [ Mon Nov 22, 2004 4:15 am ]
Post subject: 
you can buy any cheap aluminum tape at a hardware store and apply it to your car. also, you can use rubberised undercoating for cars or etc. another thing you can do is get cheaper matting from ebay and just get at least 100SQ FT
Author:  x-pride [ Thu Dec 23, 2004 11:08 am ]
Post subject: 
I say put foam tape on your license plate. Tighten everthing down. I also have used the expand a foam in certain places to help keep things tight. Like the braces on car trunks. Be careful when you use it though because a little goes a long way. But most important find out where you are rattling from.
Page 1 of 1 All times are UTC-05:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/