I found an aluminum one,thanks to Pull-A-Part
I also used a dab of Permatex thread sealant,to be extra safe. Much thanks to you both 
| 4g61t.org http://www.4g61t.org/forum/ |
|
| Crush waher on tranny drain plug? http://www.4g61t.org/forum/viewtopic.php?f=26&t=32979 |
Page 1 of 1 |
| Author: | dikdiamond [ Sun Jul 04, 2010 7:20 pm ] |
| Post subject: | Crush waher on tranny drain plug? |
Should there be a crush washer on the drain plug? I changed my fluid and a few minutes after I finished I noticed a slight leak from the bolt. There was no washer when I took it off,and I didn't give it much thought until I noticed the leak. I didn't over tighten the bolt,snugged it up. There was no leak before today. |
|
| Author: | Coltsfan [ Sun Jul 04, 2010 9:20 pm ] |
| Post subject: | Re: Crush waher on tranny drain plug? |
Yes, there totally should be an aluminum washer on there. |
|
| Author: | dikdiamond [ Sun Jul 04, 2010 10:47 pm ] |
| Post subject: | Re: Crush waher on tranny drain plug? |
Usually I question things like this,and instead of filling the transmission back up,I should have checked about a washer. I don't like doing things twice,lesson learned! Thanks Coltsfan |
|
| Author: | Flying Eagle [ Mon Jul 05, 2010 8:37 pm ] |
| Post subject: | Re: Crush waher on tranny drain plug? |
If no aluminum washer, grab an identically sized copper washer. We change drain pan washers every oil change with our imported Chev's aka, Daewoo's. |
|
| Author: | dikdiamond [ Mon Jul 05, 2010 11:09 pm ] |
| Post subject: | Re: Crush waher on tranny drain plug? |
I found an aluminum one,thanks to Pull-A-Part I also used a dab of Permatex thread sealant,to be extra safe. Much thanks to you both
|
|
| Page 1 of 1 | All times are UTC-05:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|