4g61t.org
http://www.4g61t.org/forum/

Fuel pump assembly
http://www.4g61t.org/forum/viewtopic.php?f=22&t=41104
Page 1 of 1

Author:  drcolt2000 [ Thu Aug 31, 2017 10:20 pm ]
Post subject:  Fuel pump assembly

Any ideas where I can find a new , or at least a clean fuel pump assembly for the 89 CSM hatchback?
Non turbo and turbo models must share the same gas tank and fuel assembly. Am I wrong? But I also assume the tanks and assembly are different between the sedan and hatchback.
My other thoughts are to size up a DSM assembly and modify it to suit.

Author:  cloead [ Thu Sep 07, 2017 1:03 pm ]
Post subject:  Re: Fuel pump assembly

I should have one laying around somewhere.. I'll dig a bit and see what I can find

Author:  drcolt2000 [ Sat Sep 09, 2017 9:00 pm ]
Post subject:  Re: Fuel pump assembly

Keep me posted.

Author:  cloead [ Mon Sep 11, 2017 7:27 am ]
Post subject:  Re: Fuel pump assembly

Found this in the scrap pile.. not sure if its colt or 1g

Image
Image
Image
Image

Author:  drcolt2000 [ Fri Sep 15, 2017 6:20 pm ]
Post subject:  Re: Fuel pump assembly

That might be a Colt assembly. What happened with the fuel feed line? Is that modified, or broken?

Author:  Flying Eagle [ Fri Sep 15, 2017 9:13 pm ]
Post subject:  Re: Fuel pump assembly

Compare to the fuel pickup assembly in my build thread. I compared an 89 turbo pickup and later model 4g15 pre-93. Look for gas tank restoration photos and you will be within one or two pages of where the pickup assembly photos lie.

The one pictured above would have been modified to allow for AN pass thru fitting to be used. They have a pair of nylon sandwich washers between the threaded/nut portions.

Author:  cloead [ Sat Sep 16, 2017 11:55 am ]
Post subject:  Re: Fuel pump assembly

Quote:
That might be a Colt assembly. What happened with the fuel feed line? Is that modified, or broken?

Quote:
Compare to the fuel pickup assembly in my build thread. I compared an 89 turbo pickup and later model 4g15 pre-93. Look for gas tank restoration photos and you will be within one or two pages of where the pickup assembly photos lie.

The one pictured above would have been modified to allow for AN pass thru fitting to be used. They have a pair of nylon sandwich washers between the threaded/nut portions.
Ok that sounds right, this was most likely the one that was in my 90 hatch before i went to a fuel cell. it had a bulkhead fitting in it.. 6 or 8an to hose barb inside the tank. if you want the hanger just throw me $20 and ill ship it out on monday.

shit just saw you were in canadadadada. well whatever is the cheapest shipping option to you. if you could cover that you can have it.

Page 1 of 1 All times are UTC-05:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/