4g61t.org

Specializing in the 3g CSM
It is currently Fri Mar 29, 2024 2:52 am

All times are UTC-05:00




Post new topic  Reply to topic  [ 61 posts ]  Go to page Previous 1 2 3 4 5
Author Message
PostPosted: Sun May 24, 2015 9:22 pm 
Offline
The Silent Administrator
User avatar

Joined: Wed Dec 24, 2003 3:32 pm
Posts: 9524
Location: Ottawa, ON, Canada
Last pic shows the hat under the top mount, 180 out.

I assume the issue lies mainly with where the coil end, so as to sit properly in the base?

My BG's are currently sitting 1" lower on one side of my car, hope my car isn't tweaked, because everything lines up properly.

You could cut the spring base end, with like a 1/3" coil cut and it would line up then. If you measure out the number of coils/ coil diameter and can find the

sites that discuss coil spring rates, you can see what spring rate they sent you, and determine if it will affect the height in the end. I don't think it will much.

I want to find the numbers on my spring, not sure I got them before painting them. Twice. Haha.


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 61 posts ]  Go to page Previous 1 2 3 4 5

All times are UTC-05:00


Who is online

Users browsing this forum: No registered users and 35 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Limited