| 4g61t.org http://www.4g61t.org/forum/ |
|
| Looking for a replacement vacuum barb for Greddy RZ bov http://www.4g61t.org/forum/viewtopic.php?f=22&t=35584 |
Page 1 of 1 |
| Author: | xxNocturnalxx [ Thu Nov 10, 2011 2:31 pm ] |
| Post subject: | Looking for a replacement vacuum barb for Greddy RZ bov |
Mine is broken off, tried the barbs off of greddy knock offs with no luck. I searched but can't find where to purchase these. |
|
| Author: | CSM Shaun [ Thu Nov 10, 2011 2:42 pm ] |
| Post subject: | Re: Looking for a replacement vacuum barb for Greddy RZ bov |
Lowes or a hardware store? What does the barb look like? |
|
| Author: | Red Sleeper [ Thu Nov 10, 2011 3:05 pm ] |
| Post subject: | Re: Looking for a replacement vacuum barb for Greddy RZ bov |
Quote: Lowes or a hardware store? What does the barb look like?
Its threaded on one side, and has a barb fitting on the other for a hose to slip on. haha |
|
| Author: | xxNocturnalxx [ Thu Nov 10, 2011 3:12 pm ] |
| Post subject: | Re: Looking for a replacement vacuum barb for Greddy RZ bov |
I don't have the broken piece to get a thread pitch/size from, I'll try the hardware store and see if I can get lucky. |
|
| Author: | CSM Shaun [ Thu Nov 10, 2011 3:17 pm ] |
| Post subject: | Re: Looking for a replacement vacuum barb for Greddy RZ bov |
You should be able to. It may be British Pipe Thread, but any good hardware store should have it. |
|
| Page 1 of 1 | All times are UTC-05:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|