| 4g61t.org http://www.4g61t.org/forum/ |
|
| Clutch issue http://www.4g61t.org/forum/viewtopic.php?f=22&t=34906 |
Page 1 of 1 |
| Author: | twokss [ Thu Jun 09, 2011 4:35 pm ] |
| Post subject: | Clutch issue |
My car has a full ss Dsm clutch line (master to slave), new master and slave cylinder and new act 2100 clutch that I got from 89mirageman. I bled the shot out of it but the pedal still feels weird. It goes down about halfway then engages really hard. It almost feels like your pressing a button. The trans will also not go in any gear until you start to release the clutch. Any Ideas on what it could be? |
|
| Author: | 89Mirageman [ Thu Jun 09, 2011 5:45 pm ] |
| Post subject: | Re: Clutch issue |
Sounds like you need to adjust the height of the pedal, either that or you didn't bleed it correctly. When I swapped out the master and slave cylinder on my 97 LS sedan I wasn't bleeding it right and still had issues. Then I found the how to on TRE's site and it worked perfect. I posted a link to it in one of Incoltnito's threads about a week ago. |
|
| Author: | twokss [ Thu Jun 09, 2011 6:10 pm ] |
| Post subject: | Re: Clutch issue |
Cool I'll check it out |
|
| Author: | Incoltnito [ Thu Jun 09, 2011 8:04 pm ] |
| Post subject: | Re: Clutch issue |
Yup...might have to adjust that rod on the master. Just replaced my master and did the same thing. It's easier to do with an extra person around, same goes for proper bleeding technique. |
|
| Author: | Incoltnito [ Thu Jun 09, 2011 8:07 pm ] |
| Post subject: | Re: Clutch issue |
Oooops....here's the thread http://www.4g61t.org/forum/viewtopic.php?f=22&t=34832 |
|
| Page 1 of 1 | All times are UTC-05:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|