4g61t.org

I was wondering if anyone has this answer

Are T/E/L Automatic tranny CV joints different from manual tranny CV joints (I know the Mirage ones are different just want to see if this is case on the T/E/L units)

For when I am swapping in the 4g64 I want to know which CV joints I can use to make this thing work (note I'm using an auto tranny for the 4g64 motor)

I think they're the same. I know that the 4g64 A/T M/T use the same CV axles, and that the 4g64 and 2g 4g63 M/T axles are interchangable, so it would stand to reason that they're all the same units. I don't know about 1gs though.

All i care

I just did a CV boot replacement, and I downloaded the section from the manuals you have posted. I remember that all the shaft lengths, etc were in there for the various applications. If I hadn't tossed them, I'd be able to tell you right away, but I remember there being lots of small variations between models, so a double-check is in order.

_________________
Member #533
1989 Colt GT (4G63 and a Lil 16G)Silver, 89Sonata tranny
1974 Fiat 124 Spider (Piece of S*it but I love it)
1995 Windstar (Wife's Child-bearer)

Lengths I can live with I want to make sure the inner is the same I am probably going to have to scrape up a set of c53 axles and dump them in the tranny i just want to make sure they will plug into the tranny worst case scenario if I have to match inner and outter parts I will but would prefer not to...