4g61t.org

Specializing in the 3g CSM
It is currently Wed Oct 29, 2025 10:53 am

All times are UTC-05:00




Post new topic  Reply to topic  [ 1 post ] 
Author Message
 Post subject: Wiring a evo mas in a 1G
PostPosted: Sat May 15, 2010 10:38 pm 
Offline
Spends Too Much Time Under The Hood

Joined: Thu Sep 16, 2004 10:28 pm
Posts: 383
Location: Ohio Land of colts
Don't know if anyone has ever done a write up on this. I had wired an evo8 mas into a car according to a write up Craig (gsx) found on dsm tuners. The original write up was done according to pin locations on the plugs. I preferred having it written up according to wire colors. So here it goes..

Dsm wires. Evo wires
Green/red. ------- green/yellow
Green/yellow. -------- green/white
Green/blue. -------- white/green
Red. ------- red/dots
Green/black. ------- black
Green/orange. ------- red/blue
Green/white. ------- green/blue

This was done on a 91 dsm harness with a evo8 mas air.
The mas air plug came off a newer diamante. I don't know if the wiring on a evo are the same colors. I did the write up while looking at the back of the mas air plug going from right to left with the release tab facing up. Hope this is written understandably and it can help anyone that wants to use an evo mas.

_________________
If I had a dollar for every V8 beaten by a colt I would be a millionaire. But I would still be driving my colt.


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 1 post ] 

All times are UTC-05:00


Who is online

Users browsing this forum: No registered users and 8 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Limited