4g61t.org

Specializing in the 3g CSM
It is currently Sat Nov 18, 2017 7:49 pm

All times are UTC-05:00




Post new topic  Reply to topic  [ 1 post ] 
Author Message
PostPosted: Wed Jun 25, 2003 9:16 pm 
Offline
Spends Too Much Time Under The Hood
User avatar

Joined: Mon Jan 27, 2003 11:31 am
Posts: 245
Location: Durham,N.C.
89Colt/Mirage Mas wire colors 1.6L turbo
pin 1 Idle Postion Switch........Blue
pin 2 air flow sensor..............Green/Blue stripe
pin 3 MPI control...................Red
pin 4 5v Power supply...........Green/Red stripe
pin 5 not used.......................N/A
pin 6 Ground for sensors........Green/Black stripe
pin 7 Baro. pressure sensor....Green/Yellow stripe
pin 8 Intake temp sensor........Green/Orange stripe

Colt/Mirage Mas pin order
.............................
.....4.....3....2....1....
.............................
.............................
.....8.....7....6....X....
.............................
pin 5=X not used
98 DSM wire colors 2.0L turbo
pin 1 5 volt power supply........Green/Yellow stripe
pin 2 Baro. pressure sensor.....Orange
pin 3 Airflow sensor.................Blue/Yellow stripe
pin 4 MPI................................Red
pin 5 Ground for sensors..........Black
pin 6 Intake temp sensor.........Red/Blue stripe
pin 7 Idle position....................Red/White stripe
pin 8 Not Used.........................N/A

2g Mas pin order
..........................................
..........................................
...1...2...3...4...5...6...7...X....
..........................................
..........................................
pin 8=X not used

So to summarize:

4g61 pins ---------- 2G MAF
pin 1 ---------------- Pin 7
pin 2 ---------------- pin 3
pin 3 ---------------- pin 4
pin 4 ---------------- pin 1
pin 5 ---------------- x
pin 6 ---------------- pin 5
pin 7 ---------------- pin 2
pin 8 ---------------- pin 6

Match up the 2 pins that correspond to one another.
I removed the female part from the 1g Mas so I wouldnt have to cut my wiring harness.I found this to be the easiest way.Soldering the wires to the plug then heat shrink terminals on the female plug followed by wire loom to keep it all neat looking.
Hope this helps someone please feel free to correct or add anything :D

_________________
94 Mirage Project underway...


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 1 post ] 

All times are UTC-05:00


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Limited