4g61t.org

Specializing in the 3g CSM
It is currently Mon Dec 18, 2017 12:08 am

All times are UTC-05:00




Post new topic  Reply to topic  [ 1 post ] 
Author Message
 Post subject: 14b/16G on 4g61
PostPosted: Wed Dec 31, 1969 7:00 pm 
Here is a list of parts needed to install a 14b or 16G on a 4g61 engine.

[b:570a00fn]Parts Needed[/b:570a00fn]
1G or 2G exhaust manifold, or port your 4G61 (not recommended)
1G or 2G o2 housing
MD140476 new waterpipes (these are needed to fit turbo to car)
MF650114 x2 two waterpipe banjo fittings/eyebolts
MF660065 x4 four water copper crush washers
MD117764 gasket between o2 housing and turbo
you also need the 12mm banjo for the oil line into the turbo

[b:570a00fn]Other parts[/b:570a00fn]
Not necessary but *highly* recommended from a turbo builder's standpoint:

New oil feed line MD140394
New oil return line MD150523
MD311230 new o2 sensor
New gaskets and copper crush washers.

*Info provided by Ben K.
**More info provided by Cyborg


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 1 post ] 

All times are UTC-05:00


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Limited