4g61t.org

Hey guys got another question here. I want to install an oil pressure gauge and was just wondering where the port is located to plug the oil pressure gauge into. Normally they are close to the oil filter but I have no idea where in this case. Has anyone done this mod yet and know where to find it? Thanks!

http://www.roadraceengineering.com/inst ... nstall.htm

This gives the info needed for running the turbo oil feed off the housing, you could use either port for the gauge. One is fresh filtered the other not. I use the filtered to the turbo on my mirage and the non to my gauge sender with no problems thus far.

_________________
49 International KB-2
72 Dodge Colt
73 Dodge Colt (Project)
84 GMC K3500
85 Dodge D50 Diesel Swap
90 Mighty Max V6
89 Mirage Turbo
94 Mighty Max
99 Montero

I'm trying to install the gauge in a 1.5L 4speed N/A.

Ahh, well I haven't done that... I'd agree with your first bet that there is a port near the oil filter.

_________________
49 International KB-2
72 Dodge Colt
73 Dodge Colt (Project)
84 GMC K3500
85 Dodge D50 Diesel Swap
90 Mighty Max V6
89 Mirage Turbo
94 Mighty Max
99 Montero

I think the stock sensor for the light screws directly in the front of the engine block. I would either T off of that or just replace that sensor, with a gauge you really don't need the idiot light.

_________________
93 Mitsubishi Expo LRV 1.8/manual
95 Eagle Summit DL Coupe 1.5/manual
01 Mitsubishi Mirage ES Sedan 1.8/manual

Having no luck finding this sensor. Can't really see anything in front of the engine block, exhaust manifold is in the way. Is there like an online repair manual or something that I can use to find it? I'm out of ideas at this point : /

Seems like mine was just under the exhaust manifold on my 91 colt. It threads directly into the front of the engine block. Just look for wires going to a sensor on the block.

_________________
93 Mitsubishi Expo LRV 1.8/manual
95 Eagle Summit DL Coupe 1.5/manual
01 Mitsubishi Mirage ES Sedan 1.8/manual