4g61t.org

Specializing in the 3g CSM
It is currently Wed Oct 16, 2019 3:16 pm

All times are UTC-05:00




Post new topic  Reply to topic  [ 4 posts ] 
Author Message
PostPosted: Sat Dec 22, 2018 2:48 am 
Offline
Member

Joined: Wed Feb 25, 2015 2:59 am
Posts: 44
Location: British Columbia, CA
Just doing a bit of research here.... I recently noticed in my 93 factory manual that there is a small section regarding the keyless entry system. Currently driving a 92 Colt Vista, but I am curious whether or not the keyless entry was available in 92 or even if it was supplied on the colts. To me it appears to be exclusive to the expo's but not sure.

I may have to pull off a panel or two and see if my van has it, but not holding my breath.


Top
   
PostPosted: Wed Jan 02, 2019 9:45 pm 
Offline
Moderator

Joined: Sat May 14, 2005 11:15 pm
Posts: 7510
Location: Stantonsburg, NC
My 94 Summit had it. I bought the fob on ebay and programmed it myself. Weirdly enough it would lock all of the doors fine but only unlock the driver's side door. No problem since the unlock button is easy to access.

If you have a 3 door the unit is under the panel on the driver's side by the rear seat. There's a box behind it with a tiny dip switch. It's been a few years so my memory is fuzzy. But there should be a post on here by me about it.

_________________
95 Eagle Summit DL coupe
15 Mitsubishi Mirage ES hatch


Top
   
PostPosted: Fri Jan 04, 2019 4:32 pm 
Offline
Member

Joined: Wed Feb 25, 2015 2:59 am
Posts: 44
Location: British Columbia, CA
ok thanks, i just swapped out a few things on my 92 and got to thinking... i wonder if i can use the switch from a talon door lock to get all the doors to unlock by using the key. I'll probably end up putting in an aftermarket alarm anyhow but time will tell. It took me almost two years just to get around to swapping out the door locks just so i could finally use the drivers door again to gain access. Can't even tell you how many times I forgot and tried the key only to have to go over to the passenger side. Maybe my subconscious was telling me that if i just kept trying the tumbler would somehow conform and begin to work.


Top
   
PostPosted: Mon Aug 05, 2019 1:56 pm 
Offline
Member

Joined: Fri Jun 12, 2015 9:25 am
Posts: 90
Location: new jersey
to bring this from the dead. i tried many many times to program the factory eagle oem keyless entry but had 0 luck.i gave up. then few days later got frustrated was at a friends shop(performancepartout.com).i know these are similar to a 2g in many ways. so i grabbed a 2g keyless entry module to compare plugs looked the same. and what do you know its the same plug. i brought it home and plugged it in . jumped pin 1 on obd2 to ground programmed the 2 different controls i have .. it was easy. now i have a nice remote and an ugly one.

now can anyone here PLEASE tell me why the doors lock after i unlock it please. with the remote or unlock/lock switch inside. it did it before the 2g module


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 4 posts ] 

All times are UTC-05:00


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Limited